Nightlight - Philips AVENT SCD506/52 Bedienungsanleitung

Functions and feedback on the baby unit

Nightlight

The nightlight produces a soft glow that comforts your baby.
1 Press the nightlight button on the back of the baby unit to switch on the nightlight (Fig. 14).
2 Press the nightlight button again to switch off the nightlight.
Lullaby function
1 Press the lullaby play/stop button on the baby unit to play the last selected lullaby (Fig. 15).
The selected lullaby repeats for 30 minutes.
2 Press the next lullaby button to select another lullaby from the list (Fig. 16).
3 To adjust the sound level of the lullaby, press the + or – button on the baby unit.
4 To stop lullaby playing, press the lullaby play/stop button on the baby unit.
Paging the parent unit
If you have lost the parent unit, you can use the PAGE button on your baby unit to locate the parent unit.
This function only works when the parent unit is switched on.
1 Press the PAGE button on the baby unit (Fig. 17). The parent unit produces a paging alert tone.
2 To stop the paging alert tone, press the PAGE button on the baby unit again or press any button on the
parent unit. The paging alert tone stops automatically after 2 minutes.
Battery status light
The battery status light is solid green when the baby unit is operating on battery power and the batteries
contain enough energy.
The battery status light flashes red quickly when the batteries run low while the baby unit is operating on
battery power (Fig. 18).
Note: The battery status light is off when the baby unit is powered by the adapter.
Replace the batteries when they run low.
Functions and feedback on the parent unit
Volume
There are five volume levels and a 'volume off' setting.
Setting the volume level
1 Press the + button or the - button once.
The sound level lights show the current volume (Fig. 19).
2 Press the + button to increase the volume or press the - button to decrease the volume.
3 If you do not press a button for more than 3 seconds, the sound level lights go out and the setting is
saved.
Volume off
Below the lowest volume setting, there is a 'volume off' setting.
1 Press the + button or the - button once.
The sound level lights show the current volume.
2 Press and hold the - button for more than 3 seconds to set the volume to off.
Note: The sound level lights always show that the baby produces sounds, even if the volume is set to off.
Talk function
1 If you want to comfort your baby, press the TALK button on the parent unit and talk clearly into the
microphone on the front from a distance of 15-30cm (0.5-1ft) (Fig. 20).
English
9