Linking Parent Unit And Baby Unit; Operating Range - Philips AVENT SCD506/52 Bedienungsanleitung

English
8
Manufacturer
BYD
GPI
Corun
Using the baby monitor
Positioning the baby monitor
Keep the baby unit out of the reach of the baby. Never place the baby unit inside the baby's bed or playpen.
Because the cord of the baby unit presents a potential strangulation hazard, make sure that the baby unit and
its cord are at least 1 metre/3.5 feet away from your baby. (Fig. 10)
To prevent a high-pitched sound from one or both units, make sure the parent unit is at least 1.5 metres/5
feet away from the baby unit.
Note: When the parent unit is out of range of the baby unit, the parent unit beeps from time to time. The link
indicator on the parent unit flashes red.

Linking parent unit and baby unit

1 Press and hold the on/off button on the baby unit for two seconds (Fig. 11).
- All lights on the baby unit light up briefly.
2 Press and hold the on/off button on the parent unit for two seconds (Fig. 12).
- All lights on the parent unit light up briefly.
- The 'link' light flashes red and the parent unit starts to search for the baby unit.
- When the parent unit and baby unit are linked, the 'link' light turns solid green (Fig. 13).
- If no connection is established, the 'link' light flashes red and the parent unit beeps from time to time.
Note: It takes less than 15 seconds to establish the link between the parent unit and the baby unit.
What to do if no link is established
- If the parent unit is out of range, place it closer to the baby unit, but not closer than 1 metre/3.5 feet.
- If the baby or parent unit is too close to another DECT appliance (e.g. a cordless phone), switch off this
appliance or move the unit away from this appliance.
- If the baby unit is switched off, switch it on.

Operating range

- The operating range is 330 metres/1000 feet outdoors and up to 50 metres/150 feet indoors.
- The operating range of the baby monitor varies depending on the surroundings and factors that cause
interference. Wet and moist materials cause so much interference that the range loss is up to 100%. For
interference from dry materials, see the table below.
Dry materials
Wood, plaster, cardboard,
glass (without metal, wires
or lead)
Brick, plywood
Reinforced concrete
Metal grilles or bars
Metal or aluminium sheets
Model
H-AAA850A-MB20
PH85AAAHC
Ni-MH AAA850
Material thickness
< 30cm (12in)
< 30cm (12in)
< 30cm (12in)
< 1cm (0.4in)
< 1cm (0.4in)
Rating
1.2V Ni-MH AAA/R03 850mAh
1.2V Ni-MH AAA/R03 850mAh
1.2V Ni-MH AAA/R03 850mAh
Loss of range
0-10%
5-35%
30-100%
90-100%
100%