Philips AVENT SCD506/52 Bedienungsanleitung Seite 13

English
12
Removing rechargeable and disposable batteries
To remove rechargeable and disposable batteries, see the instructions for placing and/or removing batteries
in the user manual.
Frequently asked questions
Question
Why don't the power-on light of
the baby unit and the 'link' light
of the parent unit light up when I
press the on/off buttons of the
units?
Why doesn't the battery status
light on the parent unit light up
when I start recharging the
parent unit?
Is my baby monitor secure from
eavesdropping and interference?
Why does the parent unit beep? If the parent unit beeps while the 'link' light fashes red, the connection
Why does the parent unit
produce a high-pitched noise?
Why don't I hear a sound/ Why
can't I hear my baby cry?
Why does the parent unit react
too quickly to other sounds?
Answer
Perhaps the rechargeable battery of the parent unit is empty and the
parent unit is not plugged in. Put the small plug in the parent unit and
put the adapter in a wall socket. Then press the on/off button to
establish connection with the baby unit.
Perhaps the non-rechargeable batteries of the baby unit are empty and
the baby unit is not connected to the mains. Replace the non-
rechargeable batteries or connect the baby unit to the mains. Then press
the on/off button to establish connection with the parent unit.
It takes a few minutes before the battery status lightlights up, especially
when the parent unit is charged for the first time or has not been in use
for a long period.
The DECT technology of this baby monitor guarantees no interference
from other equipment and no eavesdropping.
with the baby unit is lost. Move the parent unit closer to the baby unit
to re-establish the connection between the parent unit and the baby
unit.
If the parent unit beeps and the battery status light flashes red, recharge
the parent unit.
If the baby unit is switched off, switch on the baby unit.
The units may be too close to each other. Make sure that the parent
unit and the baby unit are at least 1.5 metres/5 feet away from each
other. It takes a few seconds for the high-pitched noise to stop.
The volume of the parent unit may be too high. Decrease the volume of
the parent unit.
The volume of the parent unit may be too low or may be switched off.
Increase the volume of the parent unit.
The microphone sensitivity level of the baby unit may be too low.
Increase the microphone sensitivity level on the parent unit.
The baby unit and the parent unit may be out of range of each other.
Reduce the distance between the units.
The baby unit also picks up other sounds than those of your baby. Move
the sound sources away from the baby unit.