Connecting The Device To The Power Grid - Kaco blueplanet 3.0 TL3 Bedienungsanleitung

Interfaces
Ethernet connection type
Torque for cable fitting
7.4

Connecting the device to the power grid

7.4.1 Configuring the AC connection plug
3
2
1
4
Fig. 11: AC connection plug
1 Nm
1 Nm
Fig. 14: Tighten screws on the housing
Key
1 Cable fitting
2 Seal
3 Housing
↻ Connection area opened.
1 Slide the cable fitting over the cable.
2 Select seal according to cable diameter used.
3 Slide the housing and seal over the cable.
4 Remove the insulation from the cable. [sl. 50 mm]
5 Shorten the wires N, L1 by 8 mm if a single-phase connection is present or shorten the wires N, L1, L2, L3 by the same
length in case of a 3-phase connection.
6 Strip the wires N, L1 in case of a single-phase connection or N, L1, L2, L3 in case of a 3-phase connection by 12 mm.
7 Flexible wires must be fitted with wire sleeves in accordance with DIN 46228.
8 Insert wires into the contacts in accordance with the markings on the contact carrier.
9 Tighten screws on contact carrier. [ S_2/
10 Press contact carriers into the housing with an audible "click".
11 Secure the housing with a screwdriver [ W_29] and tighten the cable screw fitting. [ W_29/
» Make the electrical connections.
KACO blueplanet 3.0 TL3 KACO blueplanet 4.0 TL3 KACO blueplanet 5.0 TL3 KACO blueplanet 6.5 TL3 KACO
blueplanet 7.5 TL3 KACO blueplanet 8.6 TL3 KACO blueplanet 9.0 TL3 KACO blueplanet 10.0 TL3
RJ45
5 (M25) 2.5 (M16) Nm
1,97 In
50 mm
(50mm)
6
0,47 In
12 mm
(12mm)
0,31 In
8 mm
(8mm)
5
Fig. 12: Strip the insulation from the
cable
30
6,5 Nm
Fig. 15: Tighten the cable screw fitting
4 Contact carrier
5 Line
6 Cable lengths
1 Nm]
N
PE
L1
L3
L2
N
PE
L1
L3
L2
Fig. 13: Connect wires to the contact
carrier
Fig. 16: Press contact carrier into the
housing
6.5 Nm]
Page 19