Introduction; Connections, Control, And Display Elements - Cameo EVOS W3 Bedienungsanleitung

INTRODUCTION

MOVING HEAD EVOS® W3
CLEW3
CONTROL FUNCTIONS
16-, 18-, 23-, 33-, 39-, and 43-channel control plus 11- and 18-channel dual input control
Art-Net4
sACN
Kling-Net
W-DMX™
RDM-enabled
Master/slave mode
Stand-alone functions
PROPERTIES
7 × 40 W RGB+warm white LEDs. Zoom function. Stroboscope. Pan and tilt motors with 16-bit resolution. Automatic position correction.
Temperature-controlled fans. 5-pin DMX connectors. Network connectors. Neutrik powerCON TRUE1 power connection. 2 omega mounting
brackets included. Operating voltage: 100–240 V AC. Power consumption: 325 W.
The spotlight complies with the RDM standard (Remote Device Management). Remote device management allows the user to view the
status and configuration of RDM terminals via an RDM-enabled controller.

CONNECTIONS, CONTROL, AND DISPLAY ELEMENTS

3
8
1 POWER IN
Neutrik powerCON TRUE1 power input connector. Operating voltage: 100–240 V AC / 50–60 Hz. A suitable power cable with powerCON
TRUE1 connector plug is included with product.
POWER IN
2
Neutrik powerCON TRUE1 power output connector to supply power to additional CAMEO spotlights. Ensure that the total power consumption
of all connected devices does not exceed the ampere (A) value specified on the device.
3 FUSE
Fuse holder for 5 × 0.79 inch micro fuses. IMPORTANT NOTE: Only replace the fuse with a fuse of the same type and value.
If a fuse trips repeatedly, please contact an authorized service center.
4 DMX IN
Male 5-pin XLR connector to connect a DMX control device (e.g., DMX console).
5 DMX OUT
Female 5-pin XLR connector to transmit the DMX control signal.
NET
6
RJ45 network connections to connect with an Art-Net, sACN, or KlingNet network and for connecting additional Art-Net, sACN, or
KlingNet-enabled devices to the network. Use CAT-5e, or later, cables to set up the network.
1 2
4 6
7
5 6
5