Cedes IMS 100 Pro Handbuch Seite 8

IMS 100 Pro
5.5.1 Surface mounting
Mounting box
Self tapping screws
Preassembled sensor
Expanding rivets
Figure 17:
Surface mounting (left side-opening doors)
The sensor has to be installed on the transom:
Position of mounting box
Distance:
≥ 22 mm ≤ 100 mm
Min. Distance to slam post:
Figure 18:
Position of the mounting box on the transom (left
side-opening doors)
1. Drill two 3.2 mm (1/8 inch) holes for the mounting box
with 100 mm distance into the transom.
Drill a 14 mm (0.55 inch) hole into the transom for the
sensor cable (Figure 19).
Notice:
For convenient installation use the supplied drilling
template.
Transom
Figure 19:
Drilling template
2. Disconnect the cable from the IMS 100 Pro sensor.
WARNING: Avoid pollution or contamination when the
plug is disconnected. If the connector is removed and
dust entered warranty is lost.
3. Route the cable up from the top through the 14 mm
hole (0.55 inch) in the transom to the door opening.
4. Mount the mounting box with the two 3.5 mm self-
tapping screws on the transom.
5. Connect the connector to the IMS 100 Pro housing.
6. Slide the preassembled sensor into the mounting box
and fix it with two expanding rivets.
7. Remove the foil from the optical cover after the
electrical connection but before testing.
8
Transom
≥ 22 mm
Slam post
100 12
min. 22
Hall side
5.5.2 Flush mounting
Preassembled sensor
Expanding rivets
Figure 20:
Flush mounting (left side-opening doors)
The sensor has to be installed into the transom:
Position of rectangle
Distance:
≥ 18 mm ≤ 100 mm
Min. Distance to slam post:
≥ 7 mm
Figure 21: Position of the rectangle in the transom (left side-
opening doors)
1. Cut a rectangle of 30 x 89 mm out of the transom.
2. Drill two 4.8 mm (3/16 inch) diameter holes for the
preassembled sensor into the transom with 120 mm
distance from drilling hole to drilling hole (Figure 22).
Notice:
For convenient installation use the supplied template.
Rectangle
Transom
Figure 22:
Template (Drilling and cutting out)
3. Route cable up through the hole in the transom. Slide
the preassembled sensor into the cutout and fix it with
the two expanding rivets.
4. Remove the foil from the optical cover after the
electrical connection but before testing.
English
Transom
Max. 16 mm
Slam post
89
16
120
Hall side
© CEDES | V 4.0
≥7