Left Side-Opening Doors - Cedes IMS 100 Pro Handbuch

IMS 100 Pro
The sensor has to be installed on the transom:
Position of mounting box
Transom
Min. Distance to slam post:
≥ 72 mm
Figure 12:
Position of the mounting box on the transom (right
side-opening doors)
1. Drill two 3.2 mm (1/8 inch) holes for the mounting box
with 100 mm distance into the transom.
Drill a 14 mm (0.55 inch) hole into the transom for the
sensor cable (Figure 13).
Notice:
For convenient installation use the supplied drilling
template.
Slam post
Transom
min. 72
Figure 13:
Drilling template
2. Disconnect the cable from the IMS 100 Pro sensor.
WARNING: Avoid pollution or contamination when the
plug is disconnected. If the connector is removed and
dust entered warranty is lost.
3. Route the cable up from the top through the 14 mm
hole (0.55 inch) in the transom to the door opening.
4. Mount the mounting box with the two 3.5 mm self-
tapping screws on the transom.
5. Connect the connector to the IMS 100 Pro housing.
6. Slide the preassembled sensor into the mounting box
and fix it with two expanding rivets.
7. Remove the foil from the optical cover after the
electrical connection but before testing.
5.4.2 Flush mounting
Figure 14:
Flush mounting (ride side-opening doors)
© CEDES | V 4.0
Distance:
≥ 22 mm ≤ 100 mm
100 12
Hall side
Preassembled sensor
Expanding rivets
The sensor has to be installed into the transom:
Position of rectangle
Transom
Max. 16 mm
Min. Distance to slam post:
≥ 67 mm
Figure 15: Position of the rectangle in the transom (right side-
opening doors)
1. Cut a rectangle of 30 x 89 mm out of the transom.
2. Drill two 4.8 mm (3/16 inch) diameter holes for the
preassmbled sensor into the transom with 120 mm
distance from drilling hole to drilling hole (Figure 16).
Notice:
For convenient installation use the supplied template.
Slam post
Transom
16
≥67
Hall side
Figure 16:
Template (Drilling and cutting out)
3. Route cable up through the hole in the transom. Slide
preassmbled sensor into the cutout and fix it with the
two expanding rivets.
4. Remove the foil from the optical cover after the
electrical connection but before testing.
5.5

Left side-opening doors

NOTICE
The further away the IMS 100 Pro is mounted
from the doorframe, the earlier the sensor
switches into the door mode (door has been
detected) and no longer detects objects.
English
Distance:
≥ 18 mm ≤ 100 mm
Rectangle
30
89
120
7