Cleaning The Appliance - Bosch KIF25 Serie Gebrauchsanleitung

en

Cleaning the appliance

ã=
Caution
Do not use abrasive or acidic cleaning
■
agents and solvents.
Do not use scouring or abrasive
■
sponges. The metallic surfaces could
corrode.
Never clean shelves and containers in
■
the dishwasher. The parts may warp!
Proceed as follows:
1. Before cleaning: Switch off
the appliance.
2. Pull out the mains plug or switch off
the fuse.
3. Take out the frozen food and store in
a cool location. Place the ice pack (if
enclosed) on the food.
4. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light.
5. Wipe the door seal with clear water
only and then wipe dry thoroughly.
6. Rinsing water must not run through
the drainage hole into the evaporation
area.
7. After cleaning reconnect and switch
on the appliance.
Note
Regularly clean condensation channels
and drainage hole, Fig. +, with cotton
buds, etc. so that the condensation can
run out.
36
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Fig. 4
Lift the glass shelves, pull forwards,
lower and swing out to the side.
Take out shelves in the door
Fig. 5
Lift shelves upwards and take out.
Removing the container
Fig. ,
Pull out the container all the way and lift
to detach it.
To insert the container, place on
the telescopic rails and push into
the appliance. Attach the container by
pressing it down.
Taking out the humidity filter
Fig. 1/11
The humidity filter over the humidity
container can be taken out for cleaning.
To do this, first take out the humidity
container and pull out the humidity filter.
Lift off the filter cover, Fig. -, and take
out the filter. Clean in lukewarm water,
leave to dry and re-assemble.
Installing extension rails
Fig. .
1. To remove the extension rails, bend
slightly at the front in the direction of
the arrow.
2. Lift extension rail and detach from the
mounting.
3. To install the extension rail, insert into
the rear opening.
4. Insert extension rail into the front
opening and engage downwards.