Butler 16100083 Anleitung Seite 25

Caution: The programmed brewing can
be set only when the "ON/OFF" button
is set off.
CLEANING
When cleaning the appliance, you
should pay attention to the following:
• Remove the plug from the mains
socket, and allow the appliance
to cool down completely before
cleaning it.
• Never submerge the appliance
in water and make sure no water
enters the appliance.
• Clean the appliance by wiping it
with a damp cloth. A little detergent
can be added if the appliance is
heavily soiled.
• Do not use scouring pads, steel
wool or any form of strong solvents
or abrasive cleaning agents to
clean the appliance, as they can
damage the external surfaces of the
appliance.
• The filter funnel, the permanent
filter and the glass pot can be
washed by hand in warm water with
dishwashing liquid.
• IMPORTANT! Allow to dry
completely after cleaning. Do not
use the appliance if it is damp.
• Always clean the appliance before
putting it away if it is not to be used
for a prolonged period.
DESCALING
The lime content of ordinary tap water
means lime scale may gradually be
deposited inside the appliance. This
lime scale may be loosened using acetic
acid (NOT ordinary vinegar) or descaler,
available in supermarkets, etc.
1. Mix 100 ml acetic acid with 300 ml
cold water, or follow the instructions
on the descaler packaging.
2. Pour the solution into the reservoir
and switch on the appliance using
the on/off button.
3. Allow half of the solution to run
through, and then switch off using
the on/off button.
4. Switch off for approx. 10 minutes,
and then switch on again, and
allow the rest of the solution to run
through.
5. To remove the final residues of
limescale and acetic acid, pour a
pot full of cold water into the water
reservoir, switch on and allow the
water to pass through.
6. Run fresh water through the
appliance three times (as described
in point 5). The appliance is now
ready for use.
FOR UNITED KINGDOM ONLY
Plug wiring:
This product is fitted with a BS 1363
13-amp plug. If you have to replace the
fuse, only those that are ASTA or BSI
approved to BS1362 and with a rated
current of 13 amps should be used. If
there is a fuse cover fitted, this cover
must be refitted after changing the fuse.
If the fuse cover is lost or damaged, the
plug must not be used. You must also
check if the socket outlets in your home
fit with the plug of the appliance. If the
socket outlet in your home does not fit
with the plug, the plug must be removed
and disposed of safely as insertion of
the plug into the socket is likely to cause
electric hazard. A replacement plug
should be wired according to following
description.
Important
This appliance must be earthed. The
wires in the cord set are coloured
thus:
25