Troubleshooting - Pioneer DRM-1004V40 Bedienungsanleitung

TROUBLESHOOTING

Incorrect operations are often mistaken for malfunctions. If you think that there is something wrong with this unit or error code ** E
(on the mode indicator), check the points below. A symptom which look like a malfunction is observed or error code is displayed often due to improper
maintenance, disc defect or incorrect operation. And what seems to be a serious trouble can be recovered by correcting a simple mistake or
misunderstanding or simple care of the unit. If the normal operation cannot be recovered or error code does not disappear after checking the
following, please consult a PIONEER after-sale servicing agent or your dealer.
Symptom
The door will not open.
No operation.
The power indicator does not light.
No operation.
The power indicator lights.
The disc cannot be exchanged
from the control panel.
The unit cannot be operated from
the host computer.
The disc cannot be set in the drive.
The data is not output.
After taking action according to the remedies above, switch the power of the unit OFF then ON again. If the error code is displayed or the normal
operation cannot be recovered still after this, immediately switch the power OFF again and call a PIONEER after-sale servicing agent or your dealer.
For the explanation of the error codes, refer to the error code list attached on the back side of the Changer door.
Do not use the following types of discs for they may cause
malfunction of the unit or damage to the discs:
Disc which has a molding flash (projected fin) left on the periphery
as shown in the illustration.
Disc with its edges are rounded or tapered as shown in the figure.
14
<DRC1091>
En
Display
÷ The key switch is not set to the UNLOCK
position.
÷ The door open button has not been pressed
for more than 4 seconds.
÷ The power is not supplied.
÷ The POWER switch is not switched ON.
OP
÷ The door is open.
U-L
÷ The disc is projected inside the Changer.
E83
÷ The key switch is set to the LOCK position.
÷ The SCSI cable to the Changer is not
connected properly.
÷ The Function switch and SCSI ID of the
Changer are not set properly.
÷ The disc has not been installed in the
specified address.
÷ The disc is placed upside down.
÷ The disc is scratched or dirty.
÷ Due is condensed inside the unit.
Causes
÷ Set the key switch to the UNLOCK position
using the key.
÷ Press and hold the door open button for
more than 4 seconds.
÷ Plug the power cord into the power outlet.
÷ Press the POWER switch.
÷ Close the door.
÷ Open the door, unload the magazines and
ensure that no disc is projected from
them.
÷ Set the key switch to the UNLOCK position
using the key.
÷ Check the connection cable.
÷ Check the Function switch and SCSI ID
switches.
÷ Specify an address in which a disc has
been installed.
÷ Check the disc orientation.
÷ Check that the disc is not scratched or
dirty, and exchange or clean the disc as
required.
÷ Switch the power OFF, leave the door of
the unit open for one or two hours, then
try again.
is displayed
Remedy