Function Switch Description - Pioneer DRM-1004V40 Bedienungsanleitung

FUNCTION SWITCH DESCRIPTION

The operation specifications can be selected according to the setting
of the Function switch. The Function switch is located on the side
panel to the left of the control panel and cannot be accessed unless
the front door is opened.
The Function switch is an 8-bit switch, with the top switch numbered
1 and the bottom switch numbered 8. All of these switches have been
set to OFF when the unit is shipped from the factory. Each switch can
be switched ON by flapping it up toward you.
Switches the initialize element status mode.
Switches the mail slot tray opening method.
Restricts the disc replacement operation using the
mail slot.
(For use in production line only. Do not set to ON.)
(For use in production line only. Do not set to ON.)
(For use in production line only. Do not set to ON.)
(For use in production line only. Do not set to ON.)
ON
SWITCH OFF
1 Command initialize mode
Automatic tray opening
2
The limitations in the specifications for the disc replacement
3
operation using the mail slot can be changed according to
4
the combinations of these 2 bits of switch.
Switch 1 is used to cause the automatic stored element check to
occur in case the disc presence information of the storage elements
is "unknown". It takes about 5 minutes to check all of the 100 storage
elements.
Switch 2 is used to prevent the mail slot opening operation from
occurring automatically. When the mail slot is used for the disc
replacement operation, the operability may be improved if the tray
opens automatically. However, when the safety and installation
location are taken in consideration, it is sometimes desirable to use
the manual opening mode with which the tray does not open unless
the button is pressed.
÷ Even in the manual opening mode, the tray cannot always be
opened by pressing the button. This button is valid only when its
indicator is lit.
Switches 5 to 8 are used exclusively in adjustments and testing in the
production lines and must be kept in the OFF positions.
Finally, the following description shows how the limitations in the
specifications for the disc replacement operation using mail slot can
be changed according to the combinations of switches 3 and 4.
ON
Auto initialize mode
Manual tray opening
Mode 0
OFF
Operation from control pane
Command operation from host Enabled Disabled
OFF
This is the factory setting. With this combination, the operation from
the control panel or command-based operation from the host can be
selected with the key switch.
Mode 1
ON
Operation from control pane
Command operation from host Enabled Enabled
OFF
This combination is convenient when the changer is occupied by an
individual. As the operation is not restricted even in the LOCK
position, the key which may be disturbing can be removed permanently
from the unit.
Mode 2
OFF
Operation from control pane
Command operation from host Disabled Enabled
ON
This combination is convenient when the changer is shared by a
network. The key is set to the LOCK position in normal use to inhibit
disc replacement, and set to the UNLOCK position only when disc
replacement is required.
Mode 3
ON
Operation from control pane
Command operation from host Disabled Disabled
ON
This combination is the safest setting when the changer is shared by
a network. The disc replacement is not permitted unless the person
who manages the key performs it on the control panel.
LOCK UNLOCK
Disabled Enabled
LOCK UNLOCK
Enabled Enabled
LOCK UNLOCK
Disabled Enabled
LOCK UNLOCK
Disabled Enabled
13
<DRC1091>
En