Cleaning And Maintenance; Replacing Of The Illuminant; Removing Of The Guides - Pkm EBO9.3X Bedienungsanleitung

4. Cleaning and maintenance

Switch off the appliance and let it cool down before cleaning.
Disconnect the appliance from the mains before maintenance.
 Clean the oven after use.
 Switch on the internal light while cleaning.
 Clean the interior with warm water and a little bit of washing-liquid. Use a
sponge or a soft cloth. Never use abrasive or aggressive detergents.
 Dry after cleaning.
 Clean the outside of the oven with warm soapy water. Use a sponge or a soft
cloth. Never use abrasive or aggressive detergents.
 If you use a special oven-detergent, check that the detergent is suitable for your
appliance ( instructions on the packaging of the detergent).
 Any damage that is caused to the appliance by a cleaning product will not be
fixed free of charge, even if the guarantee period of the appliance is still valid.
 Clean the door very carefully. Do not use any abrasive detergents; otherwise
you may damage or brake the glass. Use wash-up liquid and warm water.

4.1 Replacing of the illuminant

1. Switch off the appliance and disconnect it from the
mains.
2. Remove the illuminant and replace it by a new one of the
same kind and power:
 Heat-proof illuminant for ovens (300
Hz.

4.2 Removing of the guides

1. Unscrew the screws of the guides.
2. Rotate the guide vertically to make it leave the side panel.
3. Take the guide out of the side panel hole, using an approx. 45
the guide and side panel.
WARNING!
Oven
Never use a steam cleaner.
Oven-door
C), 220-240V/25W/50
0
38
angle between
0