Maintenance Intervals; Storage; General Storage Instructions; Storage During Working Breaks - Parkside PBS 2 B2 Originalbetriebsanleitung

Maintenance Intervals

Regularly carry out the maintenance work listed in the "maintenance intervals" table.
Regular maintenance prolongs the life of the equipment. It also gives optimum cutting
performance and avoids accidents.
Table "Maintenance Intervals"
Machine Part
Screws, nuts, bolts
Air fi lter
Fuel fi lter
Spark plug
Fuel hoses
Complete machine
Operating handle
Cutting head
Coupling
Lubricating the

Storage

General Storage Instructions

• Clean the equipment and accessories
carefully before storage.
• Keep the equipment in a dry and dust-
proof place out of reach of children.
• Do not wrap the equipment in plastic
bags, as damp and mould may form.
• Do not lie the device down on the pro-
tective cover.
• Use transport protection (
when storing the blades.
Action
Check, tighten
Clean or replace
Replace
Clean/adjust/replace
Check, replace if necessary
Check, clean if necessary
Check for function
Check correct installation
Check that the device is sta-
tionary when idling
gears
31/32)
A
Before
Each Use





Storage During Working
Breaks
Non-observance of the storage
instructions can cause starting
problems or permanent damage as
a result of fuel residues in the carbu-
rettor.
In case of working breaks of less
than 3 months:
1. Drain the fuel tank (7) in a well-ventilat-
ed place.
2. Start the engine and allow it to tick
over until the engine stops and the car-
burettor is free of fuel.
3. Allow the engine to cool (approx.
5 minutes).
IE
Operating Hours
10 20





NI
23