In Case Of Working Breaks Of More Than 3 Months; Transport; Disposal; Environmental Protection - Parkside PBS 2 B2 Originalbetriebsanleitung

IE NI
In case of working breaks of more
than 3 months:
4. Loosen the spark plug (
spark plug wrench (
ing/Adjusting the Spark Plug").
5. Pour a teaspoon of pure 2-stroke oil into
the combustion chamber and pull the
starter cable slowly several times to dis-
tribute the oil inside the engine.
6. Reinsert the spark plug (

Transport

• When it is being transported, the device
must be switched off and the spark plug
connector (
A
port the device when it is idling.
• Carry the device with one hand on the
upper shaft tube and the other hand on
the lower shaft tube (
to avoid coming into contact with dan-
gerous parts when transporting it (e.g.
hot engine, cutting unit).
• Use the blade guard (
transporting the blades.
• Maintain a safe distance from other
people when transporting the device.
• Do not transport the unit upside down,
as otherwise fuel might leak out.
• Before transporting between two loca-
tions, empty the fuel tank with a petrol
suction pump.
Do not empty the fuel tank indoors,
near fi re or when smoking. Gas va-
pours can cause explosions or fi re.
24
47) with a
J
23) (see "Chang-
A
47).
J
2) removed. Do not trans-
8+12) in order
A
31/32) when
A

Disposal /

Environmental Protection

Do not allow used oil and petrol residues
into the sewer system or drains.
Dispose of used oil and petrol residues
in an environmentally friendly way – take
them to a disposal point.
Take the equipment, accessories and
packaging for environmentally friendly
recycling. Machinery does not belong in
domestic waste.
Drain the petrol tank carefully and take your
equipment to a recycling point. The plastic
and metal components used can be separat-
ed by type and therefore recycled. We will
dispose of the defective equipment you send
in, free of charge. Ask your Service-Center
about this.