Initial Operation; Observe The Following Points In Particular; Filling With Fuel - Parkside PBS 2 B2 Originalbetriebsanleitung

The washer (52), clamping disk
(53) and nut (54) are not required
for mounting the spool.
Mount 3-/4-tooth blade:
2. Place either the 3-toothed or 4-toothed
blade onto the uptake spindle (51). The
blade can be used on both sides.
3. Fasten the blade using the washer (52),
clamping disk (53) and nut (54).
4. Remove the Allen key (25).

Initial Operation

Warning! Before initial opera-
tion of the equipment, it must
be checked that the condition
is safe for operation. If there
is any doubt, do not start the
equipment.
Observe the following points in
particular:
• Check the cutting tools for damage and
wear.
• Correct installation of the cutting head
• Easy movement of all switches
• Secure sit of the spark plug connector.
If the connector is loose, sparks can be
formed and thus ignite any leaking fuel-
air mix.
• Ensure the handles are clean in order to
be able to guide the equipment safely.
• All safety and protective devices must be
properly installed and in place before
the equipment can be started.
The cutting head must be able to
run freely. Before starting the equipment,
ensure that the cutting head is sitting cor-
rectly and that the moving parts are free.
Warning! If there is any
doubt, seek help with the
operation of this equipment
from a specialist in an au-
thorised service centre.

Filling with Fuel

Always ensure good ventila-
tion when handling fuel.
Do not smoke when fi lling
with fuel and keep away from
any heat sources. Never fi ll
with fuel when the engine is
running.
Open the tank cap carefully,
so any excess pressure pre-
sent can be relieved slowly.
Start the equipment min. 3
m away from the fuel fi lling
location. Risk of fi re or explo-
sion in case of non-observance
The fi lling volume
of the tank is 1200 ml.
Use only the fuel mix recommended
in the instructions. The fuel mix ages.
Therefore, do not use fuel mix that
is older than 3 months. In case of
non-observance, the engine can be
damaged and the guarantee will be
invalidated.
Avoid direct skin contact with
petrol and the inhalation of
petrol fumes. Health hazard!
gine and therefore operated exclusively
with a mix of petrol and two-stroke engine
oil in the ratio 40:1.
IE
The equipment is fi tted
with a two-stroke en-
NI
15