Putting On The Shoulder Strap; Starting The Engine - Parkside PBS 2 B2 Originalbetriebsanleitung

IE NI
Table of fuel mixtures:
Petrol
1,00 litres
3,00 litres
5,00 litres
Mixing
• Use quality unleaded petrol with an
octane rating of at least 90.
• For optimal performance, use oil for
air-cooled two-stroke engines.
1. Mix petrol and oil in the petrol mixing
canister (26).
Use the scale on the container.
2. First fi ll the petrol mixing canister (26)
with 300 ml, 400 ml or 500 ml of pet-
rol (right scale "gas").
Then add oil to the fi rst, second or third
mark on the left scale 40:1, depending
on how much petrol you have put in
the container.
Close the container and shake it.
3. Remove the fi ller cap (39) and fi ll the
fuel mixture into the petrol tank (7).
Wipe spilled fuel from around the fi ller
opening and replace the fi ller cap.
Putting on the shoulder
strap
Always wear the carrying
harness when working with
the device. Always turn the
device off before taking off
the carrying harness. Risk of
accidents.
The carrying harness is
equipped with a quick-release
device.
16
Two-stroke oil
25 ml
75 ml
125 ml
40 parts of petrol
+ 1 part of oil
Pulling the red lug (40) releas-
es the device quickly from the
carrying harness in a danger-
ous situation.
1. Put on the carrying harness (27). The
clip must be situated on the chest.
2. Adjust the strap so the spring clip is
around 10 cm below the hip.
3. Fix the spring clip onto the lifting ring
(9) on the shaft tube of the equipment.
Unhook the device before starting
the engine and fasten it to the car-
rying harness once the engine is
running.
Place the protective body (28) on
your hip between your body and
the device.

Starting the Engine

Start the engine at least three
metres from the fi lling location
Place the appliance on a solid and
even surface. Check that the blade
is not touching any objects or the
ground.
1. When using the spool:
Make sure that the protective cap on
the line cutter (
When using the 3-/4-tooth blade:
Make sure that the protective cover ex-
56) is removed.
tension (
The device is equipped with an
auto-choke. Therefore, the on/off
switch (20) will not engage in the
"START" position and will return im-
mediately to the
14) is removed.
A
position.