Cold Start; Warmstart; Operation; Working Notes - Parkside PBS 2 B2 Originalbetriebsanleitung

Cold start:

2. Place the device on a fi rm level sur-
face. Make sure that the cutting tool
does not touch either other objects or
the ground.
3. Set the on/off switch (20) to position
4. Set the choke lever (3) to position
5. Press the fuel pump (primer) (
6 times.
6. Firmly hold the device with one hand on
the upper shaft tube (8). With the other
hand, pull the starter cable on the starter
handle (4) quickly several times in succes-
sion until the motor starts.
Attention! Do not pull the starter
cable out too far - Danger of
breakage!
If the device does not start after
pulling the cable 3-4 times, set the
choke manually to position
7. Press the throttle lever (22) briefl y to en-
able the choke lever to move to position
. The device begins idling.
Allow the device to warm up briefl y.
8. To mow, keep the throttle lock (21)
pressed down and operate the throttle
lever (22).
9. To switch off the motor, set the on/off
switch (20) to position
Warm start:
1. Leave the choke lever (3) in its present
position .
2. Hold the device fi rmly with one hand
by the upper shaft tube (8). With the
other hand, pull the starter cable on the
starter handle (4) quickly several times
in succession until the engine starts.
Caution! Do not pull the starter
cable out too far - Danger of
breakage!
The device is now idling.
3. To switch off the engine, set the on/off
.
.
5)
A

Operation

Working Notes

•
•
•
.
•
•
•
(STOP).
•
•
•
•
•
•
•
•
switch (20) to position
If the engine has not started after
two attempts, try a warm start wi-
thout the choke in the warm start po-
sition. If this is not successful, follow
the instructions in the „Troubleshoo-
ting" section.
When cutting, observe the country-
specifi c / local regulations.
Do not cut during commonly applica-
ble quiet periods.
Solid objects such as stones, metal
pieces or similar must be removed.
These can be thrown out and therefore
result in personal or property damage.
When cutting in high bushes or
hedges, the working height should be
at least 15 cm. This prevents the risk to
animals, e.g. hedgehogs.
Always hold the equipment fi rmly and
securely with both hands.
Cut only grass and weeds. Be aware of
roots or tree stumps – risk of tripping.
Work considerately and endanger no-
body when cutting. Work quietly and
carefully.
Work only in adequate visibility and
lighting conditions.
Keep an eye on the cutting head.
Never cut above shoulder height.
Never replace the plastic cord with a
steel wire – risk of injury and damage.
Do not work on a ladder.
Work only on fi rm and stable bases.
Avoid an abnormal body posture.
Ensure that your footing is secure and
keep your balance at all times.
IE NI
(STOP).
17