Cleaning The Air Filter; Changing / Adjusting The Spark Plug; Sharpening The Thread Cutter; Changing The Fuel Filter - Parkside PBS 2 B2 Originalbetriebsanleitung

Cleaning the Air Filter

Never operate the equipment with-
out the air fi lter otherwise dust and
dirt enter the engine and result in
damage to the machine. Keep the
air fi lter clean.
1. Switch off the engine.
2. Undo the screw (44) on the air fi lter
cover (6) and take off the air fi lter cov-
er (6) from the air fi lter housing (45).
3. Remove the air fi lter (46) from the air
fi lter housing (45).
4. Clean the fi lter (46) with soap and wa-
ter and allow it to dry in the air
Never use petrol for cleaning!
5. Reinstall the fi lter (46) and the air fi lter
cover (6) in reverse order.
Replace the air fi lter (46) if it is
worn, damaged or dirty (see
"Spare parts/Accessories").
Changing / Adjusting
the Spark Plug
Worn spark plugs or a spark gap
that is too great will result in a
power reduction of the engine.
1. Switch off the equipment.
2. Take the spark plug connector (2) off of
the spark plug (47).
3. Screw out the spark plug (47) anti-
clockwise using the enclosed mainte-
nance key (see
4. Check the spark gap with the aid of a
feeler gauge (available from specialist
retailers). The electrode gap must
be 0.6 – 0.7 mm.
5. If necessary, adjust the gap by care-
fully bending the spark plug (47) earth
electrode.
23).
6. Clean the spark plug (47) with a wire
brush.
7. Reinsert the cleaned and adjusted
spark plug (47) or replace a damaged
spark plug (47) with a new spark plug
(e.g. "TORCH L7RTC" spark plug).
8. Reattach the spark plug connector (2).
Sharpening the
Thread Cutter
Do not use the equipment
without a thread cutter or with
a defective thread cutter.
There is a risk of injury!
Replacement line cutters are
available from our online shop
(see "Spare parts/Accessories").
Wear protective gloves to avoid
cutting injuries.
1. Switch off the equipment.
2. Unscrew the thread cutter (14) from the
protective cover (13).
3. Fix the thread cutter (16) in a vice and
sharpen the blade with a fl at fi le. File
carefully and only ever in one direction.
4. Screw the thread cutter (14) againg on
the protective cover (13).
The spare parts which are to be
ordered can be found in the "Spare
parts/accessories" section

Changing the Fuel Filter

Never operate the equipment with-
out a fuel fi lter. Change the fuel
fi lter regularly.
1. Remove the fi ller cap (39).
2. Drain the fuel tank (7) into an appropri-
ate container.
IE NI
21