Electrical Connection - Balluff BTL7-A5 M Serie Betriebsanleitung

BTL7-A/C/E/G5 _ _ -M _ _ _ _ -H/W(8)-S32/S115/_ _ _
Magnetostrictive Linear Position Sensor – Rod Style
4
Installation and connection (continued)
Supporting rod made of non-magnetizable material
Fig. 4-8: Example 2, BTL installed with supporting rod
4.4.1 Connector S32
Pin -A510 -G510
1 Not used
1)
2
3 10...0 V 10...–10 V
4
5 0...10 V –10...10 V
6
7
8
Unassigned leads can be connected to the GND on the controller side but not to the shield.
1)
Reference potential for supply voltage and EMC-GND.
2)
3) The voltage outputs may exhibit a minimal offset to the harmonized current output.
Tab. 4-2: Connection assignment BTL7...-S32
4.4.2 Connector S115
Pin -A510 -G510
1 0 V (pin 3)
2
3 10...0 V 10...–10 V
4
5 0...10 V –10...10 V
6
7
8
Unassigned leads can be connected to the GND on the controller side but not to the shield.
1)
2) Reference potential for supply voltage and EMC-GND.
Tab. 4-3: Connection assignment BTL7...-S115
10 english
Magnet
(e.g. BTL-P-1028-15R)
-C500 -C570 -E500
0...20 mA 20...0 mA 4...20 mA
0 V
10...0 V 3)
La (programming input)
0...10 V
3)
GND
2)
10...30 V
Lb (programming input)
-C500 -C570 -E500
Not used
1)
0 V (pin 5)
Not used
1)
La (programming input)
0...20 mA 20...0 mA 4...20 mA
GND
2)
10...30 V
Lb (programming input)
4.4

Electrical connection

Depending on the model, the electrical connection is made
using a cable or a connector (BTL7...-S32, BTL7...-S115)
The connection or pin assignments for the respective
version can be found in Tables 4-2 to 4-4.
Note the information on shielding and cable
routing on page 11.
-E570
20...4 mA
Fig. 4-9:
-E570
Fig. 4-10: Pin assignment of S115 (view
20...4 mA
Pin assignment of S32 (view from
above on BTL), 8-pin M16 circular
plug
from above on BTL), 8-pin M12
circular plug