Vitek VT-1687 Betriebsanweisung Seite 7

Vt-1687im.qxd 07.06.2006
Protective covering
Housing: Remove the protective film (if any) from the microwave housing.
Do not remove the light grey micaceous plate from the inside of the cooking chamber; it protects the mag
netron.
Installing the glass tray
1. Install the base for the rotating tray (B) into the opening located in the floor of the cooking chamber.
2. Install the rolling ring (C) onto the floor of the cooking chamber.
3. Carefully install the glass tray (D), aligning its lip with the grooves on the base. Never install the glass tray upside
down.
• Do not block the rotation of the glass tray during the cooking process.
• During the cooking process, always use the glass tray, rolling ring and tray base.
• Food and cooking dishes must always be placed only on the glass tray.
• The glass tray may rotate clockwise or counter clockwise. This is normal.
• Replace the tray immediately if it becomes cracked or chipped.
Installation
• Before connecting the microwave oven, make sure that the operating voltage and power usage matches the
parameters of your electrical system. Connect the microwave oven to a grounded electrical outlet.
• Install the oven on a flat, stable surface. Choose a location that will not be accessible to small children.
• Install the oven so that the distance between the wall and the back of the oven is no less than 7 8 cm and the free
space above the microwave is no less than 30 cm.
• Do not remove the legs from the bottom of the microwave oven.
• Do not block the ventilation openings on the microwave oven's housing.
• The microwave oven should be installed away from televisions and radios in order to prevent static interference of
radio and television signals.
WARNING: Do not install the microwave oven on heating surfaces (kitchen stoves) or other sources of heat
waves.
If the microwave oven malfunctions due to user error, the warranty for free service and repair is voided.
While operating, the top surface of the microwave oven and heat up significantly; avoid touching hot sur
faces of the oven with bare skin in order to prevent burns.
Using the oven
Audible signal
Each time when pressing buttons on the control panel, you will hear a single sound signal.
Double sound signal means input error. Check attentively your input and try again.
Setting the current time
Example: In order to set the current time on 16 hours 30 minutes:
1. Press and hold the CLOCK button for about 3 seconds, a signal will be heard and the display will show: Hr 24( 24
hours time display mode).
Note: Pressing the CLOCK button again toggles the time mode 12/24 hours.
2. Turn the TIME/MENU knob and set hours value to 16.
3. Press the CLOCK button to confirm.
4. Turn the TIME/MENU knob and set the minutes to 30, the display will show the time: 16:30.
5. Press the "Clock" button to confirm.
The display will show the set time; the (8) pictogram and the colon (2) will blink.
Note: if you do not complete the time setting process then, after 30 seconds, the microwave will "beep" and the dis
play will return to its initial setting.
To see the current time during the cooking process, just press the "Clock" button and the current time will be dis
played for 5 seconds.
Cooking in the microwave oven
To activate the microwave cooking mode, press the MICRO button several times to select the desired power level,
and then, by turning the TIME/MENU knob counterclockwise, select the desired cooking time.
Maximum cooking time is 95 minutes.
17:53 Page 7
7
ENGLISH