Sony PCGA-BM1 Bedienungsanleitung Seite 40

Symptom
Communication is not
possible.
Communication is not
possible although
distance between
PCGA-BM1 and
notebook is less than
100 m.
Dial-up access is not
possible.
GB
40
Cause/Remedy
c Ensure that the AC adapter is connected properly, the
power switch is turned on, and the POWER indicator is lit.
c The Bluetooth communications range may be exceeded.
Decrease the distance between PCGA-BM1 and notebook.
c DIP switch 1 (setup/normal operation mode selector) may
be set to ON. Turn power to the PCGA-BM1 off, set the
DIP switch 1 to OFF, and turn on the power again.
c Notebook may not be bonded to PCGA-BM1. Perform
Bluetooth bonding (page 19).
c Bluetooth function at notebook may have been disabled.
Consult the manuals provided with your Sony notebook
and enable Bluetooth function.
c Communication range may be less than 100 metres,
depending on obstacles between devices, interference,
operating system, software application, etc. Change the
installation location of PCGA-BM1 or otherwise decrease
the distance between devices.
c While the PCGA-BM1 is communicating with another
device (BLUETOOTH indicator on PCGA-BM1 flashes
slowly), access may not be possible. Wait until the link
with the other notebook is terminated.
c Ensure that the DIP switch 2 is set to OFF. If the switch is
ON, turn off the power of the PCGA-BM1, set the DIP
switch 1 to OFF, and turn on the power again.
c The modem driver may not have been installed correctly on
the notebook. Check this by performing the following
steps.
1 Click the "Start" button, move the pointer to "Setup",
and click "Control Panel".
2 Double-click the "Phone and Modem Options" icon to
open the "Phone and Modem Options" dialog box.
3 Select the "Modems" tab and check the list. If "PCGA-
BM1 (Modem)" is not shown, install the modem as
described in the separate information booklet "Read Me
First".