Troubleshooting - Sony PCGA-BM1 Bedienungsanleitung

Troubleshooting

If a problem occurs during operation of the unit, please check the points
listed in this troubleshooting guide. You should also consult the manuals
provided with your Sony notebook. If the problem persists, contact the
Sony dealer where you purchased this product or a Sony service
representative serving your area. For contact information, see "Getting
Help" on page 37.
Symptom
All indicators are lit
and communication is
not possible.
POWER indicator does
not light up.
Notebook tries to
access PCGA-BM1 but
unit is not recognized.
Notebook tries to
access PCGA-BM1 but
an error message
appears and
communication cannot
be carried out.
Cause/Remedy
c The reset switch on the bottom of the unit may have been
pressed. Turn power off and then on again. In this case,
stored information about notebook bonding and Passkey
will be cleared. Perform bonding again.
c Check that the AC adapter is connected properly and the
power switch is set to ON.
c While the PCGA-BM1 is communicating with another
device (BLUETOOTH indicator on PCGA-BM1 flashes
slowly), access may not be possible. Wait until the link
with the other notebook is terminated.
c A wrong Passkey may have been entered. Start the link
again and enter the correct Passkey.
If you have forgotten the Passkey, use the reset switch to
reset the unit to the factory default condition (page 31). In
this case, stored information about notebook bonding and
Passkey will be cleared. Perform bonding again.
c The maximum bonding limit of 16 notebooks may have
been reached. Delete unnecessary bonding information
(page 27). Then start the link again.
c Although the Bluetooth communication between the
notebook and the PCGA-BM1 is terminated, the dial-up
connection on the notebook could still be activated.
Continued on next page
GB
39