Regulatory Information - Sony PCGA-BM1 Bedienungsanleitung

Before using the PCGA-BM1, be sure
to read the End User Software License
Agreement that accompanies it.
Copyright laws prohibit reproducing
the software or the manual
accompanying it in whole or in part,
or renting the software without the
permission of the copyright holder.
In no event will SONY be liable for
any financial damages, or loss of
profits, including claims made by
third parties, arising out of the use
of the software supplied with this
drive.
If a problem occurs with this
product as a result of defective
manufacturing, SONY will replace
it. However, SONY bears no other
responsibility.
The software provided with this unit
cannot be used with other units.
Please note that, due to continued
efforts to improve quality, the
software specifications may be
changed without notice.
Operation of this unit with software
other than that provided is not
covered by the warranty.
Owner's Record
The model number and serial number
are located on the bottom of this unit.
Record the serial number in the space
provided here. Refer to the model and
serial number when you contact
VAIO-Link.
Model Number : PCGA-BM1
Serial Number : __________________
GB
2
Regulatory
information
Sony hereby declares that the
PCGA-BM1 Bluetooth™ Modem
Station is in compliance with the
essential requirements and other
relevant provisions of European
Directive 1999/5/EC.
Making use of the 2.4 GHz frequency
band (2.4 GHz ... 2.4835 GHz) and the
Frequency Hopping Spread Spectrum
(FHSS) technique, this product is a
radio device whose intended purpose
is to give other Bluetooth enabled
Sony notebooks access to Public
Switched Telephone Networks
(PSTN) via its built-in modem which
is intended to be used for data
communications using DTMF (Dual
Tone Multi Frequency) signalling
(tone dialling) on the PSTN networks.
Sony Bluetooth™ Modem Station
complies with all applicable
regulations in the following countries
and can therefore only be operated in:
Austria, Belgium, Germany, Ireland,
Netherlands, Switzerland, and the
United Kingdom. The PCGA-BM1
Bluetooth™ Modem Station cannot be
used in France and Italy.
The PCGA-BM1 Bluetooth™ Modem
Station has been tested and found
compliant with the limits set out in the
EMC directive using a shielded
twisted pair interconnection cable not
longer then 3 metres (9.8 feet).
The PCGA-BM1 Bluetooth™ Modem
Station complies with EN 300328-2
and EN 301489-1 for use in the
following areas: residential,
commercial and light-industrial.