Deleting Unnecessary Bonding Information - Sony PCGA-BM1 Bedienungsanleitung

10
Click the "OK" button to close the message.
11
Click the "OK" button to quit the modem station utility.
12
Terminate Bluetooth communications.
For details, refer to the manuals provided with your Sony notebook.
13
Turn off the power of the PCGA-BM1 and set the DIP switch
1 (setup/normal operation mode selector) on the bottom
panel of the unit to OFF and the DIP switch 3 (private ON/
OFF selector) to ON.
The new Passkey becomes valid when you turn on the power of the
PCGA-BM1 again.

Deleting unnecessary bonding information

The supplied modem station utility can be used to check which notebooks
have been bonded to the PCGA-BM1. It is also possible to delete bonding
information that is no longer needed.
The maximum number of notebooks that can be bonded to the PCGA-BM1
is 16. To bond further notebooks, bonding information must be deleted
first.
Note
If the modem station utility is not installed, it must first be installed as described on page
25.
1
Set the DIP switch 1 (setup/normal operation mode selector)
on the bottom panel of the unit to ON and the DIP switch 3
(private ON/OFF selector) to OFF.
For details, refer to "DIP Switch Settings" on page 17.
2
Turn on the power of the PCGA-BM1.
GB
26