Sony PCGA-BM1 Bedienungsanleitung Seite 14

Attaching the base
Preparation
When installing the PCGA-BM1 for the first time, make a note of the serial
number of the unit shown on the serial number label. This number is
required as a Passkey for bonding notebooks (see page 19). For the location
of the label, refer to "Bottom view" in the section "Names of Parts" on
page 12.
Note
If the Passkey becomes known to other persons, they can perform Bluetooth bonding of a
computer to the PCGA-BM1 and use it to access a dial-up service which may incur
charges to the subscriber. Always handle your Passkey (serial number) with care, in order
to prevent unauthorized access.
1
Align the three grooves on the base with the corresponding
protrusions on the bottom of the unit and join the two parts
together.
2
Slide the unit in the arrow direction until it clicks into place.
The base should be situated at the bottom when joining the parts.
Bring the telephone
cable out as shown.
Note
Take care not to pinch the telephone cable when joining the parts.
GB
14
1
2
Protrusion
Groove