Possible Cause - Tecsis P3230 Betriebsanleitung

9. Trouble shooting
Failure
Signal span dropping off/too small
Signal span drops off
Signal span erratic or incorrect
Abnormal zero point signal
Zero point signal unstable/ too low/high Moisture present (e.g. at the cable tail)
Hot instrument case surface
In case of unjustiied reclamation we charge the reclamation handling expenses.
*) Make sure that after the assembly the unit is working properly. In case the error continues to exist send in the instrument for
reparation (or replace the unit).
Betriebsanleitung/Operating instructions

Possible cause

Diaphragm is damaged, e.g. through
impact, abrasive/agressive media;
corrosion of diaphragm/pressure
connector; transmission luid missing.
Moisture present (e.g. at the cable tail) Install the cable correctly
Working temperature too high/too low
Medium or ambient temperature too
high/too low
Diaphragm is damaged, e.g. through
impact, abrasive/agressive media;
corrosion of diaphragm/pressure
connector.
Working temperature too high/too low
Permissible ambient or medium tempe-
rature exceeded
Procedure
Contact the manufacturer and replace
the instrument
Ensure permissible temperatures as
per the Operating Instructions
Control the internal temperature of
the instrument within the permissible
range; observe the allowable tempera-
ture error (see Operating Instructions)
Replace instrument
Ensure permissible temperatures as
per the Operating Instructions
Install the cable correctly,
ilter element insertion
Ensure permissible ambient/medium
temperature limits are observed (see
Operating Instructions)
GB
25