Utilization; Warranty - CONDTROL Auto RotoLaser Bedienungsanleitung

EN
ROTARY LASER
11) Remove batteries from the product if it not used for a long time.
12) Do not leave discharged batteries in the product.
13) Avoid heating the batteries to avoid the risk of explosion and
electrolyte leakage. In case of liquid contact with skin, wash it
immediately with soap and water. In case of contact with eyes, flush
with clean water during 10 minutes and consult the doctor.

UTILIZATION

Expired tools, accessories and package should be passed for waste
recycle. Please send the product to the following address for proper
recycle:
Condtrol GmbH
Wasserburger Strasse 9
84427 Sankt Wolfgang
Germany
Do not throw the product in municipal waste!
According to European directive 2002/96/ЕC expired measuring tools
and their components must be collected separately and submitted to
environmentally friendly recycle of wastes.

WARRANTY

All Condtrol GmbH products go through post-production control and
are governed by the following warranty terms. The buyer's right to
claim about defects and general provisions of the current legislation
do not expire.
1) Condtrol GmbH agrees to eliminate all defects in the product,
discovered during the warranty period, that represent the defect in
material or workmanship in full volume and at its own expense.
2) The warranty period is 24 months and starts from the date of
purchase by the end consumer (see the original supporting document).
20
CONDTROL Auto RotoLaser
user manual
CONDTROL Auto RotoLaser
EN
ROTARY LASER
3) The Warranty doesn't cover defects resulting from wear and tear
or improper use, malfunction of the product caused by failure to
observe the instructions of this user manual, untimely maintenance
and service and insufficient care, the use of non-original accessories
and spare parts. Modifications in design of the product relieve the
seller from responsibility for warranty works. The warranty does not
cover cosmetic damage, that doesn't hinder normal operation of the
product.
4) Condtrol GmbH reserves the right to decide on replacement or
repair of the device.
5) Other claims not mentioned above, are not covered by the warranty.
6) After holding warranty works by Condtrol GmbH warranty period is
not renewed or extended.
7) Condtrol GmbH is not liable for loss of profit or inconvenience
associated with a defect of the device, the rental cost of alternative
equipment for the period of repair.
This warranty applies to German law except provision of the United
Nations Convention on contracts for the international sale of goods
(CISG).
In warranty case please return the product to retail seller or send it
with defect description to the following address:
Condtrol GmbH
Wasserburger Strasse 9
84427 Sankt Wolfgang
Germany
user manual
21