Care And Maintenance - CONDTROL Auto RotoLaser Bedienungsanleitung

EN
ROTARY LASER
3. Turn off the product. Move it to the opposite wall, position of the
product should remain unchanged.
4. Turn on the product. Align laser line with the previously made point
Y2. Mark point Y3 on the opposite wall.
5. If distance between points Y1 и Y3 is more than 3 mm – turn off the
product and contact service center.
18
CONDTROL Auto RotoLaser
user manual
CONDTROL Auto RotoLaser
EN
ROTARY LASER

CARE AND MAINTENANCE

Rotary laser is a high-precision instrument and requires careful
handling. Before using as well as after physical impact (falling, hitting)
carry out accuracy check.
Observation of the following recommendations will extend the life of
the device:
1) Store the product, spare parts and its accessories beyond reach of
children and unauthorized people.
2) The instrument should be transported in the off state inside the
case only.
3) Do not store the product in dusty or dirty locations. The product is
dust and dirt resistant, but long-time exposure to these elements may
damage internal moving parts of the product.
4) Store the product in dry locations. The product is water resistant,
but precipitate, humidity and liquids containing minerals may damage
the electrical circuits of the product. Do not try to dry the unit by fire
or a hairdryer.
5) Do not store the product in locations where temperature is more
than +50°С. High temperatures reduce the life of electronic devices,
damage batteries, deform or melt some plastic parts.
6) Do not store the product in locations where temperature is less
than -10°С.
After storage in low temperature conditions and subsequent transfer
to a warm room, the device is heated, causing moisture condense
inside the instrument and damage the chip.
7) Protect the instrument from bumps, drops, strong vibrations. This
can lead to loss of accuracy.
8) Carry out accuracy check regularly (see paragraph «Accuracy
check»).
9) To clean the product use a soft wet cloth. Do not use harsh
chemicals, cleaning solvents or detergents.
10) Сlean laser aperture periodically with a soft lint-free cloth with
isopropyl alcohol.
user manual
19