Other Operations - Olympus mju-III 80 Bedienungsanleitung

EN

OTHER OPERATIONS

REWINDING THE FILM MID-ROLL
Press the mid-roll rewind button with the
1
protrusion on the strap buckle
use an instrument with a sharp tip.
Unload the film as described on page 7.
PRINTING THE DATE/TIME
(Quartzdate model only)
First select the date/time mode you
want to print. Press the MODE
None
button. Each time you press it, the
mode will switch in the order shown
Year-month-day
on the left. Keep the mode you want
Month-day-year
to print displayed. Date/time is
imprinted in the lower right corner of
Day-month-year
the picture. If the date/time is
Day-hour-minute
superimposed on a bright color like
white, orange, yellow, etc., it may be
difficult to read. When black-and-
white film is used, the date/time may
not be printed.
CORRECTING THE DATE AND TIME
(Quartzdate model only)
Be sure to correct the date and time after the battery has been inserted or
replaced.
1. Keep the MODE button pressed until the "year" indicator starts blinking.
2. Press the SET button to adjust the "year" indicator. If you press the
button once, the number on the display will advance by 1. If you keep
the button pressed, the numbers will run in rapid succession. If you
pass the intended number, keep pressing to return to that number.
3. Press the MODE button once more to make the "month" indicator blink.
Press the SET button to adjust the "month" indicator. As you press the
MODE button, the blinking indicator changes in the order of "year",
"month", "day", "hour" and "minute".
4. Repeat Steps 2 and 3 to set "hour" and "minute". Make sure the
"minute" indicator is blinking.
5. When "minute" has been set, press the MODE button. None of the
indicators will be blinking and date/time correction is now complete.
12
OTHER OPERATIONS
REPLACING THE REMOTE CONTROL BATTERY
(Optional RC-300C)
1
. Do not
If the selftimer/remote control indicator doesn't blink even when you
press the button, replace the battery with a new one (CR2025).
1. Turn the screw on the bottom of the remote control counterclockwise to
loosen.
2. Turn the remote control over, and remove the cover. With the battery
facing up, remove the old battery and insert a new battery as shown.
3. Replace the cover, turn the remote control over, and turn the screw on
the bottom clockwise to tighten (see figure 9 on page 151).
EN
13