Spot Metering - Olympus mju-III 80 Bedienungsanleitung

EN SPECIAL FEATURES
High contrast —

SPOT METERING

When taking photos in a high contrast environment (e.g. backlight
portraits), the main subject may come out too dark or too bright. To make
sure that the subject is exposed correctly use Spot Metering (see figure 7
on page 150).
Position the spot marks (A) on the area where you want to measure the
light. Press the shutter release button halfway; the green lamp lights and
the focus and exposure are locked on that area. Reframe your subject and
press the shutter release button all the way.
SETTING THE SPOT MODE
Press the flash mode button ( ) and
the selftimer/remote control button
simultaneously. Press them again to
cancel the mode.
SETTING THE SELFTIMER/REMOTE CONTROL
Press the selftimer/remote control
Mode display Mode
button. The mode switches in the order
No
shown on the left. The selected mode
—————
display
is displayed on the LCD Panel.
Selftimer
Remote Control
Camera Shake
Indicator
Selftimer
Secure the camera on a tripod or other support. Compose your shot in the
viewfinder. Press the shutter release button halfway (the focus and
exposure are locked at this time). Then press the shutter release button all
the way. The selftimer indicator lights for about 10 seconds and then blinks
for about 2 seconds. After this, the shutter will release.
10
SPECIAL FEATURES
Remote Control RC-300C (Optional)
Compose your shot in the viewfinder. Position the autofocus frame on your
subject. To take a picture, point the remote control at the camera and
press the button on the remote control. The selftimer/remote control
indicator starts blinking, and the shutter will release about 3 seconds later
(see figure 8 on page 150).
Camera Shake Indicator
In this mode, the camera warns you before you shoot if camera shake is
likely to cause blurring. Also, when there is significant camera shake, this
mode helps reduce blurring. If the green and orange lamps blink
alternately when you hold the camera, it means that the camera is shaking
and blurring may result. Hold the camera securely until the lamps stop
blinking; then press the shutter release button.
EN
11