Electrolux ESF 6610ROW Benutzerinformation Seite 28

28 www.electrolux.com
How to adjust the level of the
water softener
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to "Set-
ting and starting a programme".
2. Press and hold, at the same time, De-
lay and Option until the indicators
, and
3. Press Program,
6.2 Filling the salt container
6.3 Filling the rinse aid dispenser
start to flash.
A B
A
+ -
C
D
• The indicators
• The indicator
• The display shows the current set-
ting of the water softener, e.g.
= level 5.
4. Press Program again and again to
change the setting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt contain-
er (only for the first time).
3.
Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out from
the salt container when you fill it.
Risk of corrosion. To prevent it,
after you fill the salt container,
start a programme.
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the
released quantity (B) between po-
sition 1 (lowest quantity) and posi-
tion 4 (highest quantity).
and go off.
continues to flash.