C Hanging Cables; C Hanging Bulb - Fagor HPM-199 Serie Bedienungsanleitung

99633311 notice FAGOR 2004_ML.qxd
Downloaded from www.Manualslib.com
C
hanging cables
• The supply cable (H05 RR-F, H05 RN-F or H05 W-F) must be long enough to allow
the oven to rest on the floor in front of its housing.
With the oven sitting on the floor and disconnected:
• Open the trapdoor at the bottom right hand side at the back of the oven by
removing the 2 screws and swinging the door away.
• Remove the sheath from each wire in the new cable up to 12 mm.
• Twist the ends carefully together.
• Unscrew the terminal screws and remove the wires that need changing.
• Pass the new cable through the wire clamp to the right of the terminals.
• Connect the wires up in accordance with the markings on the terminals.
• Make sure all wires are trapped under the screws.
• The brown wire (live) going to terminal marked L.
• The green and yellow wire (earth) going to the one marked
• The blue wire (neutral) going to the terminal marked N.
• Tighten the screws and check, by tugging on each wire, that they are firmly connected.
• Tighten the clamp to hold the cable.
• Close the trapdoor using the two screws.
We cannot accept any liability in the event of an accident
resulting from non-existent or faulty earthing.
C
4. hanging a bulb
• The light bulb is housed in the ceiling of your oven.
Warning! Switch off the power at the main switch before
attempting to change the bulb. Leave the oven to cool if necessary.
a) Unscrew the protective shade
(see diagram).
b) Unscrew the bulb in the same
direction.
A bulb is used:
- 15 W
- 220-240 V
- 300°C
- E 14 screw-fitting bulb
c) Change the bulb, replace the shade and switch your oven back on at the mains.
It is easier to unscrew the shade and bulb if you wear a rubber
glove.
manuals search engine
22/06/04 10:07 Page 97
How to install your oven
bulb fitting
unscrew
cover
GB
.
97