Conversions/Changes/Spare Parts; Interruption Of Operation; Fault - Conel CLEAR FILL Montage- Und Betriebsanleitung

52
6.9

CONVERSIONS/CHANGES/SPARE PARTS

Only original spare parts may be used!
Unauthorised conversions and changes are forbidden for safety reasons. These
can impair the functioning of the heating circuit filling station and cause leaks.
The imprinted approval marks are only valid if original spare parts are used.
6.10

INTERRUPTION OF OPERATION

To stop the flow of water to the heating circuit filling station, the upstream and downstream shut-off valves
must be closed.
When disassembled, the heating circuit filling station must be stored in a dry and frost-free location and
protected against contamination and damage.
7

FAULT

Opening of devices and replacement of parts subject to water pressure must only
be performed by licensed persons to ensure the safety and leak-tightness of the
devices.
Troubleshooting:
Fault
There are leaks.
Bottle does not deliv-
er the required water
hardness.
Warning message
Display shows LOW
BAT
Cause
Water hardness slowly increases
once the capacity has been ex-
hausted.
Low battery voltage.
Remedy
The installer or the closest customer service
point must be informed immediately!
Replace bottle (see chapter 6.7).
Change batteries.