Dangers Due To Non-Observation; Electrial Devices/Installations - Conel CLEAR FILL Montage- Und Betriebsanleitung

Our recommendation:
CLEAR FILL heating filling block with two integrated shut-off valves, pressure reducer, pressure gauge
and Type BA system separator (see fig. 1).
4.3

DANGERS DUE TO NON-OBSERVATION

In particular, non-observation of the general danger symbols is associated with the following typical haz-
ards:
/ Failure of important heating unit functions,
/ Endangering of persons due to electrical and mechanical effects,
/ Endangering of persons and the environment due to leaks.
Any working methods that might endanger safety must be avoided.
Non-observation of these operating instructions and the safety instructions herein may endanger per-
sons, as well as the environment and the device itself.
4.4

ELECTRIAL DEVICES/INSTALLATIONS

No electrical cables and equipment may be located below or in the immediate vi-
cinity of the heating circuit filling station!
Electrical devices/installations that are not splash-proof and are located in the vicinity of the heating cir-
cuit filling station may be damaged by water that escapes during installation or in the event of incorrect use
of the heating circuit filling station.
If the electrical devices/installations are connected to the power supply, it is also possible that a short-cir-
cuit could occur.
Should this occur there is a risk of electric shocks to people.
Therefore electrical devices/furnishings and equipment in the vicinity must be splashproof and/or comply
with the legal regulations for wet areas.
37