Replacing The Battery - Conel CLEAR FILL Montage- Und Betriebsanleitung

Always store the resin bottle vertically after removing it from the heating circuit filling
station or cap!
When replacing a bottle, the cap of the replacement bottle is unscrewed. It can be
used on the consumed bottle to prevent water from running out.
/ Use the keypad to select the new bottle type (see chapter 6.3).
The display will now show the remaining capacity of the new bottle.
/ Install and bleed the new bottle (see chapter 5.4).
/ Completely open the upstream and downstream shut-off valves and continue the filling process if nec-
essary.
/ Dispose of the consumed bottle with general household rubbish.
6.8

REPLACING THE BATTERY

Once the battery voltage is too low, a warning message appears on the display:
The batteries then need replacing.
/ Remove both insulation shells (see fig. 3).
/ Remove the electronics housing.
The two batteries are located in the electronics housing.
/ Replace the batteries with new ones of the same type (AAA).
Note the battery positions! The poles are marked with + and - symbols.
/ Put the electronics housing and insulation shells back in place.
Disposing of used batteries:
This symbol on the battery indicates that the battery of this product must not be
disposed of with general household rubbish after use. If the battery features the
chemical symbols Hg, Cd or Pb, the mercury, cadmium or lead content of the bat-
tery exceeds the reference values specified in EC Directive 2006/66. If batteries
are not properly disposed of, they can cause harm to human health and/or the en-
vironment.
Please do not dispose of the batteries with general household rubbish but instead
at your local battery recycling facility.
LOW BAT
51