Vitek VT-1207 BN Betriebsanweisung Seite 6

ENGLISH
STEAM CHAMBER CLEANING
To prolong iron lifetime we recommend cleaning
the steam chamber, especially in the regions
with "hard" water.
Set the continuous steam supply knob (3)
–
to the position «
ply is off).
Fill the water tank (10) till the "MAX" mark
–
(13).
Place the iron on its base (8).
–
– Insert the power plug into the socket.
Set the temperature control knob (11) to the
–
max. temperature, the pilot lamp (9) will light
up.
When the soleplate temperature (14) reaches
–
the desired temperature value, the pilot lamp
(9) will go out. Wait till the soleplate is hot
again, then you can start cleaning the steam
chamber.
Unplug the unit.
–
Hold the iron above the sink horizontally,
–
press and hold the self-clean button (12)
(pic. 7).
Boiling water and steam with scale will be
–
released from the iron soleplate (14) open-
ings.
Slightly sway the iron back and forth, until
–
water goes out of the water tank (10).
– Place the iron on the base (8) and let it cool
down completely.
Once the soleplate (14) cools down com-
–
pletely, wipe it with a dry cloth.
Before you take the iron away for storage,
–
make sure that there is no water in the water
tank (10) and that iron soleplate (14) is com-
pletely dry.
CLEANING AND CARE
Before cleaning the iron, make sure that it
–
is switched off and has cooled down com-
pletely.
Clean the unit body with a damp cloth and
–
then wipe dry.
Scale on the iron soleplate can be removed
–
with a cloth soaked in vinegar-water solution.
After removing scale, polish the soleplate
–
surface with a dry cloth.
Do not use abrasive substances to clean the
–
soleplate and iron body.
VT-1207.indd 6
» (continuous steam sup-
Avoid contact of iron soleplate with sharp
–
metal objects.
STORAGE
Set the temperature control knob (11) to the
–
"MIN" position and the continuous steam
supply knob (3) to the position «
supply is off).
Unplug the unit.
–
Open the water inlet lid (2), turn over the iron
–
and drain any remaining water from the water
tank (10) (pic. 8).
Close the lid (2).
–
Set the iron vertically and let it cool down
–
completely.
Wind the power cord.
–
Store the iron vertically in a dry cool place,
–
out of the reach of children.
DELIVERY SET
Iron – 1 pc.
Beaker – 1 pc.
Instruction manual – 1 pc.
TECHNICAL SPECIFICTAIONS
Power supply: 220-240 V, ~ 50 Hz
Power consumption: 2200 W
The manufacturer preserves the right to
change the specifications of the unit without a
preliminary notification.
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim under
the terms of this guarantee.
This product conforms to the EMC-
Requirements as laid down by the
Council Directive 89/336/EEC and to
the Low Voltage Regulation (73/23 EEC)
6
» (steam
16.10.2012 15:16:36