Advice On Use; Assembly; Attaching The Blade Guard (See Fig. A) - Parkside PDKS 120 Bedienungs- Und Sicherheitshinweise

suitably qualified person or at the Customer
Service Centre.
J
Always work with the mains lead leading
away from the rear of the device.
J
If a dangerous situation arises, pull the mains
plug immediately out of the mains socket.
J
Always switch on the electrical power tool before
moving the workpiece against it. Otherwise
there is the risk of kickback.
J
Do not cut moist materials or damp surfaces,
J
Use only undamaged, defect-free saw blades
Distorted or blunt saw blades
cause a kickback.
J
Ensure that the teeth on the saw blade
downwards before you mount it in the device.
J
DANGER OF INJURY! Keep your hands
away from the area of the saw blade.
J
Before sawing, check the workpiece for foreign
bodies such as nails etc. and remove them. In-
jury and / or damage to property may result from
the saw blade striking nails etc. embedded in
the workpiece.
J
Always keep the device clean, dry and free
from oil or grease.
J
Switch off the device before you remove any
wood residue from around the saw blade.
Otherwise you could become injured.
WARNING!
VAPOURS! Any noxious dusts or vapours
generated from sawing represent a risk to the
health of the person operating the device and
to anyone near the work area.
J
Do not saw materials containing substances
harmful to health.
J
Do not use the tool on materials containing
asbestos. Asbestos is a known carcinogen.
J
Make sure you have adequate ventilation.
J

Advice on use

Q
J
Push the workpiece slowly and with minimum
pressure on to the saw blade.
J
Reduce the rate of advance when you are
cutting thicker material.
Downloaded from www.Manualslib.com
can break or
7
HAZARDOUS DUSTS /
Wear protective glasses, hearing
protection, dust protection masks
and protective gloves.
manuals search engine
J
Hold the workpiece firmly on the table with
both hands and push it slowly towards the saw
blade. Otherwise the saw blade may twist or
break.
J
Avoid making any sharp changes in direction
during sawing to prevent the saw blade from
twisting or tearing.
J
Before starting the saw cut, drill a hole at a
corner or internal cut-out in the workpiece and
start sawing from the hole.
J
. Use the correct saw blade. The choice of saw
7
blade depends on the thickness and type of
material and the intended cut.
point Select a saw blade with fine teeth to saw thin,
7
hard materials.
Use a narrow saw blade to saw small radius
cuts.

Assembly

Q
WARNING!
Pull the mains plug out of the socket before you
carry out any task on the device,
Attaching the blade guard
Q
(see Fig. A)
j
Push the screw
slot in the blade guard
j
From the outside of the blade guard
the guide plate
The bent-up side of the guide plate
around the blade guard
j
Attach the blade guard
tachment arms
through the openings provided for them in the
attachment arms
j
Ensure that the upwardly curved end of the
blade guard
j
Put the plain washers
of the attachment arms
j
Screw the knurled nuts
ends
10 c
j
Slide the blade guard
tion and fix it in that position by tightening the
knurled nuts
Safety advice / Assembly
DANGER OF INJURY!
from the inside through the
10 c
.
9
on to the screw
10 b
10 b
.
9
between the two at-
9
and insert the two screws
11
.
11
is at the top.
9
on from the outside
10 a
.
11
on to the two screw
10
.
into the desired posi-
9
.
10
9
, place
9
.
10 c
engages
10 c
GB 9