Loading The Battery; Turning The Camera On And Off - Concord Eye-Q Go 2000 Kurzanleitung

LOADING THE BATTERY

The Concord Eye-Q Go 2000 uses one 3V CR123 lithium
battery.
Loading the Battery:
1. Locate the battery door on the bottom of the camera.
2. Slide the battery door outwards, as indicated by the arrow
and lift the battery door to open. (fig.1.1)
3. Insert the 3V CR123 lithium battery with the positive
terminal (+) toward the inside of the battery compartment.
(fig.1.2)
4. Close the battery door, press down on it and slide it
towards the center of the camera until it snaps into place.

TURNING THE CAMERA ON AND OFF

1. Press the On/Off button
will beep when it is turned on.
2. To turn the camera off, press the On/Off button
for a few seconds. (fig.1.3)
USING THE MMC/SD
Inserting the MMC/SD:
1. Locate the battery cover on the bottom of the camera.
2. Slide the battery door away from the camera body and lift
the battery door to open.
3. Insert the MMC or SD memory card as indicated by the
arrow. (fig.1.4)
4. Close the battery door. Press down on it and slide it
towards the center of the camera until it snaps into place.
Downloaded from www.Manualslib.com
for a few seconds. The camera
manuals search engine
2
fig.1.1
fig.1.2
fig.1.3
fig.1.4