Loading The Battery; Turning The Camera On And Off; Taking Pictures - Concord Eye-Q Go! Kurzanleitung

LOADING THE BATTERY

Before taking pictures, a 3V (CR123A) Lithium battery
must be inserted into the unit.
1. Using your thumb, open the battery compartment by
pressing down on the battery door and sliding it
outwards as indicated by the arrow.
2. Insert a 3V Lithium battery (CR123A). Make sure to
observe the polarity (+/-) as indicated in the figure.
3. Close the battery compartment door.

TURNING THE CAMERA ON AND OFF

1. To turn the camera on, press and hold down the
ON/OFF button (
on.
2. To turn your camera off, press and hold down the
ON/OFF button (
blank, indicating the unit has powered off.

TAKING PICTURES

1. Turn your camera on and make sure the review
switch is in CAPTURE mode.
(The review switch should be in the position furthest
away from the shutter button.)
2. While looking into the viewfinder, hold the camera
steady and press the SHUTTER BUTTON until the LED
in the viewfinder stops blinking and you hear the
camera beep, indicating that the picture has been
taken. The frame counter will subtract one from the
total number of pictures available.
Downloaded from www.Manualslib.com
) until the Status LCD screen turns
I
); the Status LCD screen will turn
I
manuals search engine
2