Getting Started; Setup And Connection; Risk Of Fire; Use - Silvercrest SIKP 2000 C1 Bedienungsanleitung

Getting started

Setup and connection

Place the device on an even, non-slip and dry surface.

Risk of fire!


Do not place the device on textile surfaces such as a tablecloth.

Do not place the device unit on metal surfaces. These can heat up quickly and cause a
fire.

Never place the device under flammable items such as curtains.

The openings on the bottom of the product must never be covered. Keep a distance of at
least 10 cm clear all around the device and at least 60 cm clear above it to guarantee
sufficient cooling.

Use


If you switch the induction hotplate off and the surface temperature of the heating zone is
higher than 60 °C, "H" is shown on the display. If the temperature drops below 60 °C,
the display shows "L".

If you remove the pan from the induction hotplate when in use and the surface
temperature of the heating zone is greater than 60 °C, the display shows "H-EO" and a
beeper sounds every 4 seconds. After around 45 seconds, the beeper stops and only
"H" is displayed. About a minute later, the device switches itself off. The display continues
to show "H" as long as the surface temperature of the hotplate is greater than 60 °C. If
the temperature drops below 60 °C, the display shows "L".

When the hotplate is switched on, the preset power level is 1000 W.
1. Connect the hotplate to a live wall socket using the power cord (1). A beeper then sounds and the
display (3) shows "L" or "H" depending on the temperature.
2. Place a pan on the hotplate (2).
Warning about property damage

The pan must be explicitly suitable for induction hotplates. Do not use any other pans
(e.g. ceramic ones).

Be careful when preparing soups and stews. The weight of the cooking vessel and the
contents together must not exceed 10 kg.
SilverCrest SIKP 2000 C1
English - 13