Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX operation
Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 12 control channels.
However, it can also be switched to a mode with 6 or 8 channels if different functions are required. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1
Select the Address Setting menu item and set the DMX start address. Confirm with the ENTER button.
2
Call the menu item Running Mode > DMX and set the desired number of DMX channels.
3
The display indicates 6CH (6 DMX channels), 8CH (8 DMX channels) or 12CH (12 DMX channels). Use
the buttons UP and DOWN to select the desired DMX channel mode. Confirm with the ENTER button.
4
Now the display indicates the menu item for the DMX start address d***. Use the buttons UP and DOWN
to set the address. Confirm with the ENTER button.
5
The dot will flash when DMX signals are being received. If no control signals are available, the dot will
not light
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Functions in DMX mode
6-Channel mode
Channel:
1
000 – 255
Ambient light
2
000 – 255
Ambient light
3
000 – 255
Ambient light
4
Segment 1
000 – 255
COB LED
5
Segment 2
000 – 255
COB LED
6
Segment 3
000 – 255
COB LED
Value:
Function:
Brightness Red, 0-100%
Brightness Green, 0-100%
Brightness Blue, 0-100%
Brightness 0-100%
Brightness 0-100%
Brightness 0-100%
26/32
00125443, Version 1.1
Werbung
Inhaltsverzeichnis
