Connection To The Mains; Operation; Operating Buttons - EuroLite HONEYCOMB Bedienungsanleitung

Connection to the mains

The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1 Connect the device via the mains cable to a grounded mains socket. Thus the unit is switched on.
2 To switch off the unit, disconnect the power plug.
3 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
4 The jack POWER OUT allows for power supply of further devices. To interconnect several devices,
connect the jack POWER OUT to the input POWER IN of the next unit until all units are connected.
Matching power cables with P-Con plugs are available as accessories. In this manner, up to 8 devices
can be linked at 230/240 input voltage and up to 4 devices at 110/115 input voltage.

OPERATION

After connection to the mains, the device is ready for operation. The display shows the last operating mode
set. Now make the necessary menu settings for the respective operating mode using the operating keys.
Even if you disconnect the unit from the mains, all settings remain stored. The device can be operated either
in stand-alone mode via the control panel or in DMX-controlled mode via a commercially available DMX
controller.

Operating buttons

MENU
ENTER
UP
DOWN
SAFETY EYELET
DMX IN DMX OUT
POWER IN POWER OUT
DMX
MENU UP DOWN ENTER
CONTROL
DMX512
HONEYCOMB
ABL Spot
To select the operating mode.
Activates the setting mode of a menu item or saves a setting.
Selects the next menu item or increases values when modifying.
Selects the previous menu item or decreases values when modifying.
SAFETY EYELET
DMX IN DMX OUT
POWER IN POWER OUT
DMX
MENU UP DOWN ENTER
CONTROL
DMX512
HONEYCOMB
ABL Spot
24/32
SAFETY EYELET
DMX IN DMX OUT
POWER IN POWER OUT
DMX
MENU UP DOWN ENTER
CONTROL
DMX512
HONEYCOMB
ABL Spot
00125443, Version 1.1