Requirements For The Place Of Installation - Conel CLEAR 2.0 RD Montage- Und Betriebsanleitung

36
In addition this may also result in short circuits if these electrical devices/equipment being connected to
the electrical power supply.
In the event of such cases persons are at risk and may sustain electrical shocks.
Therefore any electrical devices/equipment situated in the direct vicinity should be splash-water proof, re-
spectively comply with the statutory requirements for wet areas (IP44).
5

REQUIREMENTS FOR THE PLACE OF INSTALLATION

To ensure trouble-free operation, the requirements listed below must be adhered
to:
/ The ambient temperature must not exceed 30 °C (86 °F)! At higher temperatures or direct sun radia-
tion the material can be damaged and the filter hood can even break.
/ In order to be able to safely discharge the wastewater (backwashing) in operation and in case of any
defects that occur in the system, precise compliance with the details given in the chapter 6 "INSTAL-
LATION" is necessary!
If the wastewater (backwashing) cannot be safely and completely discharged, the house and installa-
tions can be damaged by water.
/ The room where the unit is installed must be dry and frost free. Unauthorised persons must not have
access to the domestic water station.
/ The domestic water station must not be exposed to strong shocks.
/ A shutoff valve must be installed upstream of the domestic water station! Thus, the water supply can
be interrupted during installation, maintenance, repair and malfunction of the domestic water station.
Floodings and serious water damage to house installations can be avoided this way.
/ The unit can be installed in all standard drinking water pipes.
/ It is not permitted to install the domestic water station upstream of the water meter!
Always install the domestic water station in a vertical position! Failure to observe
this can cause uncontrolled backwashing water to escape and can result in water
damage.