Getting A Fingerstick Sample - Micropoint qLabs ElectroMeter Handbuch

ADD BLOOD
120S

9.6 Getting a Fingerstick Sample

Good fingerstick technique is beneficial to both the professional user and
the patient. Getting a good fingerstick will ensure minimal discomfort for
the patient and accurate test results for the user. Please sanitize the site of
the fingerstick with alcohol wipe before testing.
9.6.1 Maximize Good Blood Circulation
1) If needed, briefly warm the hand in warm water or with a
heating pad.
2) Massage the finger with a downward motion several times
before performing the fingerstick.
3) Lower the hand to below the heart level when collecting the
blood drop.
When qLabs ElectroMeter is ready for
®
sample testing, it will beep and prompt the
user to apply a blood sample.
9.6.2 Identify a site on the finger to puncture
1) On one of the middle fingers of either
hand.
2) Near the top of the finger on either side.
3) Away from any calluses or scars.
9.6.3 Clean the selected area with 70%
isopropyl alcohol, or an alcohol pad.
Dry thoroughly with cotton or gauze.
18
EN