Bluetooth Settings; Lot Number Setup; Setting A Target Range For Your Inr Results - Micropoint qLabs ElectroMeter Handbuch

8.5 Bluetooth Settings

BLUETOOTH
OFF
NEXT
-
OK

8.6 Lot Number Setup

LOT NUMBER
ON
NEXT
-
OK
NOTE: Please make sure the date setting is correct if you want to use the
input function of LOT NUMBER.

8.7 Setting a Target Range For Your INR Results

An INR target range may be set to alert the user when the INR results are
out of range.
If results fall outside the target range, or if results fall within
the target range but are not consistent with the patient's
current state of health (e.g. they have symptoms such
as bleeding or bruising) follow your usual procedures for
taking corrective action.
Press "+" or "-" buttons to turn on/off the
bluetooth. When the Bluetooth function is
on, the user can use optional Bluetooth
dongle to connect the meter to the user
management software.
+
Please refer to the Data Manager manual for
Bluetooth driver installation and usage.
You can press the functional "+" and "-"
buttons to enable or disable the LOT
NUMBER input function. If the LOT NUMBER
input function is enabled, you will be asked
to enter the Lot Number before performing
+
each test. The Lot Number contains the
expiration date of the strip. The meter will
check whether the current date exceeds the
expiration date of the strip. If the current date
exceeds the expiration date, the meter will
report an error.
13
EN