Selecting Displayed Units; Selecting Language; Language √ English - Micropoint qLabs ElectroMeter Handbuch

TARGET: OFF
0.7 1.4
NEXT
-
OK
If you would like to reset the settings, press the "NEXT" button to go back
to the date setting. Repeat section 8.2 until the desired setting is selected.
NOTES:
• In the Setup Mode, pressing the "OK" button will complete all
setup steps and save your settings, then return to the display that
prompts the user to insert a test strip.
• If the power is cut off, current settings will be lost and the qLabs
ElectroMeter will reset to the factory default settings. To save
settings, install / replace the batteries while keeping the power
adapter connected to the power supply.

8.8 Selecting Displayed Units

UNITS
√ PT/INR/QC
PT/INR
INR

8.9 Selecting Language

LANGUAGE
√ ENGLISH
FRANçAIS
DEUTSCH
ITALIANO
NOTE:
• The language option may be different, depending on the software
configuration.
press the "OK" button. The system will save
your settings and will return to the display
that prompts the user to insert a test strip.
The "LO" or "HI" message will not be flashing
+
on your test result.
You can use the right button or the left
button to select one of the three display
modes, which are INR, PT/INR and PT/INR/
QC.
You can use the right button " " or the left
button " " to select the desired language
and then press the "OK" button to return to
the main menu.
15
EN EN
®