Powering The Qlabs Electrometer On And Off; Power Connection; Powering The Qlabs ® Electrometer On - Micropoint qLabs ElectroMeter Handbuch

7. Powering the qLabs
ON and OFF

7.1 Power Connection

The qLabs ElectroMeter comes with a power supply which must be
®
plugged into the qLabs
qLabs ElectroMeter can use 4 standard AA batteries (See Section 12.2).
®
The messages on the four-cell grid displayed at the bottom
of the screen provide hints for the functions of the buttons.
7.2 Powering the qLabs
OFF
SET MEM
VER
When the qLabs
®
choices to power on the monitor:
1. Press and hold the "Power" button for 2 seconds to turn on the
qLabs ElectroMeter, or
®
2. Insert a fresh test strip if you are ready to perform a test. The
qLabs ElectroMeter will then prompt you to confirm the strip code.
®
Turning the qLabs
• Perform a test, or
• check the version of the software and the manufacturer information
by pressing the "VER" button, or
ElectroMeter power supply jack. Alternatively, the
®
ElectroMeter On
®
When the qLabs
powered on, it will beep and prompt to insert
a test strip automatically.
ElectroMeter is in the standby mode, you have two
ElectroMeter ON in CHOICE 1, allows the user to:
®
V2.4.6.10
MICROPOINT
023000E0900009
ElectroMeter
®
ElectroMeter is initially
®
S/N
9
EN