Troubleshooting - Beko CEG5331X Bedienungsanleitung

6

Troubleshooting

Problem
The appliance does not work.
No or delayed response in several trials of
pressing on function key on the panel
The coffee is not hot enough.
The coffee cannot come out from spout.
The first cup of coffee is poor quality.
Coffee has no cream.
The touch buttons are not sensitive
The appliance takes too long time to warm up.
The water tank is removed / the water level is
very low in the water tank but have no alert.
Internal drip tray is filled with a lot of water.
Coffee is delivered too slowly or a drop at a
time.
Lack of bean indicator flashes but there is still
a lot of coffee bean inside the container.
No milk foam out from the machine
Fully Automatic Coffee Machine / User Manual
Cause
The appliance is not connected to the mains.
- Appliance is under an electromagnetic
interference
- Dirt over the panel
- The cups have not been preheated.
- The brewing unit is too cold.
Empty system function maybe used before.
The first run of grinder does not pour
sufficient quantity coffee power into the
brewing unit.
- Coffee bean is not fresh.
Not pressing the touch button from the front
direction of the appliance
Excessive scale has built up.
The area near the water tank connector is
wet.
Coffee powder too fine which block the water
to come out.
Coffee powder too fine which block the water
to come out.
Internal coffee powder outlet is blocked.
The automatic milk frother is dirty or not
assembled or installed correctly
Solution
- Plug in and press the switch.
- Check the cable and the Plug
Unplug the appliance. Restart after few
minutes Clean the panel with the cloth
provided
Rinse the appliance at least 3 times before
making the coffee.
Press the hot water button until water can
come out from spout.
Throw the coffee away. The other coffees
will always be of good quality.
Change or using appropriate brand of coffee
bean.
Press the lower bottom part of the icon of the
touch button from the front direction of the
appliance.
Descale the appliance.
Wipe the water around the water tank
connector
Adjust the coffee fineness to bigger dot
during grinder operation.
Adjust the coffee fineness to bigger dot
during grinder operation.
To follow the steps of section E (V. Cleaning
coffee powder outlet).
Clean the automatic milk frother and make
sure it is correctly assembled or installed.
25 / EN