Inhaltsverzeichnis
Werbung
DRAWINGS | DISEGNI | DESSINS | DraWINGS | DIBUjOS
12 | BELAYING OF 1 OR 2 SECONDS IN A SELF-LOCKING WAY
This mode allows the belaying of one or two seconds. After the setup and before the belaying you must test the system:
pull on the rope on the climber's side to verify that the self-locking function stops the rope on the climber's side.
12.1
SETUP
Insert the rope in slots B
ref. to symbols 9-10 (1).
Insert a wide-base HMS
karabiner in the hole G
with the rope inside (2).
12 | BELAYING OF 1 OR 2 SECONDS IN A SELF-LOCKING WAY
This mode allows the belaying of one or two seconds.
12.5
BELaYING 2 SECONDS
When using half or twin
ropes, always hold both
free ends of the ropes
firmly in your hands and
taut!
WEB_IST12-2D651CT rev.2 11-12
12.2
SETUP
2
1
Connect the Concept ka-
rabiner at the center of the
belay station and connect
it in the hole I, so that the
ropes remain below it.
12.6
WarNING!
NO!
always hold both free
ends of the ropes firmly
in your hands and taut!
12.3
TESTING
Pull on the rope on the
climber's side to verify that
the self-locking function
stops the rope on the
climber's side.
12.7
GraDUaLLY rELEaSING
quickdraw
karabiner
Insert a quickdraw karabiner
in the hole L, hold both free
ends of the rope firmly in your
hand and push your palm up.
- 9 -
12.4
BELaYING 1 SECOND
Use both hands to take up
slack at the climber end
through the device. hold
the free end of the rope
taut in both hands.
www.climbingtechnology.com
Werbung
Inhaltsverzeichnis
