Storage; Troubleshooting - Bosch MUM54Q-Serie Gebrauchsanleitung

Cleaning the continuous-feed shredder
All parts of the continuous-feed shredder are
dishwasher-proof.
Tip: To remove the red film after processing
e.g. carrots, pour a little cooking oil on a cloth
and rub the film off the continuous-feed shredder
(not the cutting discs). Then rinse the continuous-
feed shredder.
Cleaning the blender
The blender jug, lid and funnel are dishwasher-
proof.
Tip: After processing liquids, it is often sufficient
to clean the blender without removing it from the
appliance. Pour a little water and washing-up
liquid into the attached blender.
Switch on the blender for several seconds
(setting M). Pour out the water and rinse
out the blender with clear water.
Important information
If required, clean accessories bag.
Follow care instructions in the bag.

Storage

Fig. 
Store tools and cutting discs in the

accessories bag.
Keep accessories bag in the bowl.

To store in the original packaging, see Fig. .


Troubleshooting

Robert Bosch Hausgeräte GmbH
Important information
The Operating indicator flashes if the appliance
has been operated incorrectly or the electronic
fuse has tripped or the appliance is defective.
The swivel arm must be engaged in every
operating position.
Initially try to eliminate the problem which
has occurred with the help of the following
information.
Fault
Appliance does not start.
Remedial action
Check the power supply.

Check the mains plug.

Check swivel arm. Correct position?

Engaged?
Screw on blender or bowl as far as possible.

Attach the blender cover and screw on as far

as possible.
Attach drive cover to unused drives.

The safety lock is active. Switch appliance

to 0/off and then back to the required
setting.
Fault
Appliance switches off during use.
The overload protection feature has been
activated. Too much food was processed
at one time.
Remedial action
Switch off the appliance.

Reduce processing quantity.

Do not exceed permitted maximum
quantities (see "Application examples").
Fault
While the drive was running, the release button
was inadvertently pressed.
The swivel arm moves up. The drive switches off,
but does not stop in the tool change position.
Remedial action
Set the rotary switch to 0/off.

Move swivel arm to position 1.

Switch on appliance (setting 1).

Switch off appliance again.

Tool stops in tool change position.
en
119